Accessing USB Device via the USB Device Connector on the conduit back panel.

Home › Forums › Conduit: AEP Model › Accessing USB Device via the USB Device Connector on the conduit back panel.

Tagged: , ,

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 4, 2017 at 4:10 pm #18147
    Ajay K
    Participant

    I just was planning to connect to a serial device to the conduit, however was not sure if I can connect the serial device to the USB Device connector on the back panel of the conduit? If I can is it possible to perform serial communication via node-red and communicate via the USB device connector on the conduit back panel?

    Thanks,
    Ajay

    April 4, 2017 at 4:28 pm #18158
    Peter Ferland
    Blocked

    You can connect a USB serial port to the “USB Host” connector and it should be recognized by the kernel and the appropriate /dev entry should appear. You must then manually configure a “Serial” node for the serial port.

    April 4, 2017 at 6:30 pm #18160
    Ajay K
    Participant

    Thanks Peter for taking the time to respond and for your inputs. However
    when you say

    You must then manually configure a “Serial” node for the serial port.

    Are you talking about doing that in node-red or is this a linux related configuration step? I am little new to the configuration requirements around Linux OS.

    Thanks,
    Ajay.

    April 5, 2017 at 8:42 am #18162
    Peter Ferland
    Blocked

    Thats the node red node.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.