Robert Lengyel

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 17, 2017 at 2:43 pm in reply to: Stuck in "joining network" loop #17332
    Robert Lengyel
    Participant

    Hi Leon,

    I have the mDot surface mount, so I can definitely access the debug port as its on a PCB. However, I’ll solder on some wires to do so.

    Is this issue something that is known, ie, a bug in firmware? And if so, what specific commands / scenarios do I have to avoid in order to prevent this from happening. I’m hoping that the future modules will fix this problem.

    February 16, 2017 at 5:59 pm in reply to: Stuck in "joining network" loop #17279
    Robert Lengyel
    Participant

    Hello,

    Unfortunately, I’ve gotten this problem as well, but I cannot flash new firmware / custom firmware to fix this. Is there any other way to reset the device completely? I think the problem is with the AUTO OTA mode. I am unable to send any commands to the module; it is completely blocked. I’ve tried the nReset pin, but that did not work either.

    Any ideas?

    Robert

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)