I am using the mDot Box product.

Home › Forums › mDot/xDot › I am using the mDot Box product.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • June 18, 2017 at 11:22 pm #19584
    TaeYang
    Participant

    Is there a way to supply power to the battery, other than 9V?

    June 26, 2017 at 3:26 pm #19668
    Leon Lindenfelser
    Moderator

    Hi Tae,

    If you open the DotBox, you should see a USB connector just below the on/off slide switch. Assuming it is there, that can be used to power the DotBox. You could cut a hole in the plastic case to provide access. It only provides power. The data lines are not connected.

    Kind regards,
    Leon

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.