packet failures
- This topic has 1 reply, 2 voices, and was last updated 7 years, 4 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › packet failures
Leon Lindenfelser.
Danny LeeHi,
I have a mDot connected to AEP gateway and placed right beside of gateway.
I have been measuring uplink packet failure rates for each of channels (1-8) and noticed that channel 6 and 7 gives relatively a larger number of packet failures than other channels. Are there any particular reasons for it?
Thank you
Regards,
Danny
Leon LindenfelserHi Danny,
I don’t know why there is a difference in the packet failure rate between frequencies. However, I know that placing the mDot too close to the gateway can be a problem as the signal can be too high and may get clipped. Do you have antennas attached? When I do close proximity testing, I remove the antennas. Please see how it performs with no antennas or move them away from each other.
Kind regards
Leon