ADR – How can you tell if node has enabled it?

[Lawrence Griffiths]

Hi I have an end node that purports to using ADR.
I’ve configured the AEP for min DR of 3
It’s stuck on SF12
The end node is aprox 2 meters away from GW and has been running for a day days sending 200+ msg of typical is SnR 6.8 I would expects to see end node DR change? GW firmeware 1.3.2

How can see if the end node ADR bit is set in uplink header?
What is the opts key (“opts”: “0306”) in the lora In msg?

{ “chan”: 1, “cls”: 0, “codr”: “4/5”, “datr”: “SF12BW125”, “freq”: “868.3”, “lsnr”: “6.8”, “mhdr”: “400100000082dd00”, “modu”: “LORA”, “opts”: “0306”, “port”: 20, “rfch”: 0, “rssi”: -28, “seqn”: 221, “size”: 4, “timestamp”: “2017-06-06T21:23:40.964616Z”, “tmst”: 2886538412, “payload”: [ 2, 0, 61 ], “eui”: “0e-7e-34-64-33-30-67-44”, “_msgid”: “4c3b1193.b3c4f” }

Thanks
Lawrence

[Ajay K]

Hi Lawrence,

I had asked a similar question a while back, look at Mike Fiore’s response to figure out if ADR is enabled or not correctly and can be found at the very bottom of the forum thread.

http://www.multitech.net/developer/forums/topic/enabling-adr-on-the-mdot-and-conduit-issue/

Thanks,
Ajay

[Lawrence Griffiths]

Ajay thanks for this

[Author]

Posts