Dragonfly Nano Power supply
- This topic has 7 replies, 3 voices, and was last updated 5 years, 5 months ago by
makepe3rddopl5@bestmagneticgenerator.com.
-
AuthorPosts
-
February 12, 2020 at 11:39 am #30263
Junaid Farooqi
ParticipantI am confused in designing a board for Dragonfly nano. The power supply for Dragonfly Nano is 3.3V or 5V for proper operation?
The datasheet says that supply voltage range is 3.3V to 5.25V DC but Developer’s kit say that we have to give 5V supply for Dragonfly devices. What supply I have to use to power up the Dragonfly Nano?February 12, 2020 at 11:56 am #30264Leon Lindenfelser
ModeratorUse the electrical characteristics information from the Dragonfly Nano device guide not the developer kit documentation. Sorry for the confusion.
Kind regards,
LeonFebruary 12, 2020 at 12:06 pm #30265Junaid Farooqi
ParticipantThanks Leon. Do you mean I can power up Dragonfly Nano directly from 3.7V LiPo battery?
February 12, 2020 at 12:13 pm #30266Leon Lindenfelser
ModeratorYes, the acceptable operating voltage is 3.2v-5.25v.
February 12, 2020 at 12:31 pm #30267Junaid Farooqi
ParticipantOn page#20 of “MTQN-MNG1-B01 Device Guide”, there is a table of power consumption. This table shows 2 different input voltages (3.8V & 5.0V) but current consumption is only given for 5V except of sleep mode. And for current in sleep mode is not given against 5V input. Why is it so?
February 12, 2020 at 1:46 pm #30268Leon Lindenfelser
ModeratorI’m checking on the power consumption table. All functionality is there across the voltage range. So it has nothing to do with limitations at certain voltages. That said, I’ll let you know what I find out.
I want to add some clarification about what the developer guide stated regarding 5v on the Dragonfly. There is a jumper on the board “TARGET VOLTAGE” that can be used to set the voltage supplied to MDOT or MTSMC types of devices to 3.3v or 5v. That jumper does not apply to the Dragonfly. Dragonflies will be powered by 5v unless you get a bit more creative and place a jumper from the 3.3v pin of the “TARGET VOLTAGE” connector to the appropriate pin of the 2 pin connector next to the Dragonfly connector.
February 12, 2020 at 5:07 pm #30270Leon Lindenfelser
ModeratorI don’t have a good reason for why the table is populated as it is other than the full complement of measurements was not taken for each voltage. Are there some specific power draw questions you have that I can help with?
July 25, 2020 at 1:41 am #31015makepe3rddopl5@bestmagneticgenerator.com
ParticipantThe suspensory ligament arises from How To Make Penis Bigger Naturally Fast too as gives dorsal assistance also as stabilization of your erection by attaching midline towards the penile underlying ( 2 ).
-
AuthorPosts
- You must be logged in to reply to this topic.