Jeff Clemmer

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 6, 2016 at 10:05 am in reply to: ADR #13707
    Jeff Clemmer
    Participant

    Thanks. Looking at the log I noticed this:

    20:8:41:956|DEBUG| ADR rxDR : 0 stDR : 4 avgSnr: -26 pwr: 30
    20:8:41:956|TRACE| Send ADR command
    20:8:41:957|DEBUG| ADR update command: DR4 PWR: 30
    20:8:41:957|DEBUG| DR grp: 3 mask: 00ff
    20:8:41:957|DEBUG| ADR txpower: 30 index: 0
    20:8:41:958|DEBUG| ADR node 02:00:00:02 setting DR4

    I don’t have ADRStep specified in my config, so it should be at the default of 30. Since the average SNR is negative, why is it asking the node to jump from DR0 to DR4? This just causes our node to jump to DR4, and then have to drop down to get through.

    Do you have more information on how ADRStep is used – understanding that each step is 3dB, but is it just a table – if avgSNR is between 0dB and 3dB it is DR4, -3dB and 0 it is DR3, etc…? If what is the initial point it starts at and bases the subsequent steps off of?

    February 25, 2016 at 1:27 pm in reply to: wifi for mlinux Conduit #11767
    Jeff Clemmer
    Participant

    I’m also having a similar issue trying to get usb wifi working

    January 28, 2016 at 3:26 pm in reply to: mlinux resolv.conf issue #11453
    Jeff Clemmer
    Participant

    Thanks! This worked for me as well.

    January 28, 2016 at 3:02 pm in reply to: Lora network server #11452
    Jeff Clemmer
    Participant

    I’m also interested in how this is configured. I was told by someone from Multitech that this wasn’t possible, even in 0.0.9?

    Thanks

    January 25, 2016 at 11:48 am in reply to: Restrict OTAA to specific devices? #11321
    Jeff Clemmer
    Participant

    Thanks – any plans for this?

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)