FAIL.TXT error
- This topic has 0 replies, 1 voice, and was last updated 7 years, 9 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Hi,
I’m flashing a new board and most are OK, however I’m seeing a couple of instances of the FAIL.TXT file with the following contents:
FAIL: The interface firmware FAILED to reset/halt the target MCU
Can you tell me what this means and how to fix it? Is this a bad connection to the xDot? The boards are being flashed from a xDot DK using the recommended Samtech cable as detailed in the xDot Developer guide.
I have a number of custom boards produced already and this is the first time I’ve seen this particular error.
Regards
Andrew