Conduit AP (MTCAP-L4E1)
- This topic has 4 replies, 2 voices, and was last updated 3 years, 3 months ago by .
Viewing 5 posts - 1 through 5 (of 5 total)
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › Conduit AP (MTCAP-L4E1)
Tagged: Firmware Access Page Issue
I was configuring the multi-tech conduit AP (MTCAP-L4E1).
Initially, I have login the firmware using http://192.168.2.1, successfully set time, and register the LoRaWAN driver. But now I cannot log in into the firmware setup. It says, this site cannot be reached, when I window network diagnostic, it shows that
Your computer appears to be correctly configured but the device or resource (http://192.168.2.1) is not responding. How could I resolve this?
I have turned off window firewall and antivirus too
Also, check IP4 is on
Hello
Can you specifically try https://192.168.2.1 rather than http://192.168.2.1
Yes, I tried.
Hi
Have you tried clearing the cache on the Browser or try a different Browser.
Depending on what you previously configured in the device, for example if you configured the Ethernet (eth0) interface as a WAN it is possible to lock yourself out of the device if remote access via WAN is not enabled.
As a last resort you can always factory default the Gateway by holding in the ‘Reset’ button for 31 seconds.
I think it is highly like that I did this.
I try to start it with factory settings.
Kind regards