Conduit gateway switching between eth0 and ppp0

Home › Forums › General › Conduit gateway switching between eth0 and ppp0

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 3, 2018 at 3:02 pm #25888
    William Laing
    Participant

    Good day –

    I noticed the public IP address of our gateway changed.

    It transitioned from our local wired network (public IP address of the university) to the another IP address, which I’m guessing is the cellular network.

    My question is: what are the criteria for switching between Ethernet and cellular? I see traffic for both eth0 and ppp0 shown on DeviceHQ for the same time period.

    Thanks in advance for your help.

    August 3, 2018 at 3:14 pm #25889
    Steve Kovarik
    Moderator

    Hi William

    In the ConduitAEP under “Setup” then “WAN” if you have multiple WAN’s
    configured you set priority for a primary WAN and a secondary WAN to
    failover to. An ICMP (10 count ping) failure will trigger a WAN failover.

    August 3, 2018 at 3:45 pm #25890
    William Laing
    Participant

    Awesome, Steve, that’s what I wanted to know, thanks!

    And have a great weekend.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.