Cannot communicate from Mdot to Xdot using AT Command

Home › Forums › mDot/xDot › Cannot communicate from Mdot to Xdot using AT Command

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 18, 2017 at 5:56 pm #21189
    William Huang
    Participant

    Dear All,

    I am currently trying to use mdot to communicate with xdot by AT firmware. I have successfully compiled the AT firmware program and drag it into the Xdot kit and I also have checked the baud rate, data bits, parity and stop bit setting are correct in the serial setting. However, I cannot get the Xdot to response when I type AT command in the terminal program. So I just want to get some suggestion and ideas.

    Thanks

    October 18, 2017 at 10:30 pm #21190
    William Huang
    Participant

    Hi,

    I just get things solved by reading a past post in this forum. But I have another question, do I just set my own network address, network session key and data session by myself? Second, what are the transmit data rate and transmit frequency for AU915?

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.