Dean Simonelli

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 6, 2017 at 3:28 pm in reply to: Accessing conduit via WAN #19444
    Dean Simonelli
    Participant

    Well I somewhat got it working, only from the computer I am tethering the wifi off of. Anyway I solved my issue.

    June 6, 2017 at 2:05 pm in reply to: Node-Red Help! #19442
    Dean Simonelli
    Participant

    Yes that is very true, I should be using the file in and out nodes.
    Thanks

    May 31, 2017 at 5:44 pm in reply to: mDot not responding to AT commands #19374
    Dean Simonelli
    Participant

    Ah ha, found the problem, for me at least. I had previously flashed the Dot-Examples Auto_Ota_Example program onto the mDot. Therefore the mDot was configured into Auto-Ota mode. After flashing the mDot firmware, it does not reset this setting and therefore you don’t have control over it. It connects automatically.

    My fix: Change the Dot-Examples to the regular OTA program. Flash that onto the mDot, let it run so it configures to OTA mode. Then flash the mDot firmware back onto it. Ta dah, fixed.

    Hope that helps 🙂

    May 31, 2017 at 5:02 pm in reply to: mDot not responding to AT commands #19372
    Dean Simonelli
    Participant

    I have the same issue right now, I’ve had this problem before but I forgot how I fixed it. I believe it has something to do with the firmware not flashing correctly/not resetting properly.

    Although mine is going “Joining network…” “Network join failed” then repeat forever.

    I’ll let you know if I figure out a fix.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)