Charith Mendis

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 6, 2012 at 5:22 pm in reply to: MTSMC-G2 GPRS #4119
    Charith Mendis
    Participant

    If possible can you detail out the AT command sequence for

    GPRS connection establishment

    IP stack activation

    and getting down data from a HTTP request

    The documents do not show the sequence (order) properly even though the AT commands are listed there.

    I have now requested for the document S000469A

    August 6, 2012 at 4:24 pm in reply to: MTSMC-G2 GPRS #4117
    Charith Mendis
    Participant

    Actually I only have the GSM / GPRS module. I need to download data via HTTP through GPRS using AT commands typed from Hyperterminal. Is it possible? Then, what would be the AT command sequence?

    I thought the modem itself had an IP stack.

    August 6, 2012 at 3:43 pm in reply to: MTSMC-G2 GPRS #4115
    Charith Mendis
    Participant

    This is the module I have bought.

    http://www.digikey.com/product-detail/en/MTSMC-G2/591-1113-ND/2164038

    Can you give out the sequence of AT commands for example to download a html page from http://www.google.com

    I am stranded here due to the lack of documentation in the developer’s guide. Thank you

    August 2, 2012 at 3:50 pm in reply to: MTSMC-G2 not connecting to network #4101
    Charith Mendis
    Participant

    Thank you very much it worked when I selected 5.

    Also, another query; I couldn’t find whether the reset pin of the module is active low or active high in any data sheets. Can you verify whether it is active high or low?

    Also, whether it is internally pulled up or down?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)