xdot/mdot operating frequency

Home › Forums › mDot/xDot › xdot/mdot operating frequency

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 12, 2019 at 8:44 am #27228
    Chad Goyette
    Participant

    I have a line of devices that use the xDot module (XDOT-NA1) in the US. I was wondering if it’s possible to change the operating frequency in software to operate in Europe? This would be preferred so I wouldn’t require new additional inventory of devices and could just create new firmware for the Europe application. Also, would this apply to mDot as well? (I assume it would).

    February 12, 2019 at 8:56 am #27229
    Jason Reiss
    Keymaster

    The xDot/mDot hardware does not include hardware filters. The firmware controls the frequencies used.

    The US models have the FCC stamp on the label and EU models have CE stamp.

    February 12, 2019 at 9:04 am #27230
    Chad Goyette
    Participant

    Is it acceptable to print the CE label and place it on the device for the EU application?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.