How to receive the data from Multitech Conduit mlinux gateway to RN2483 Module

Home › Forums › Conduit: mLinux Model › How to receive the data from Multitech Conduit mlinux gateway to RN2483 Module

Viewing 1 post (of 1 total)
  • Author
    Posts
  • June 15, 2016 at 12:23 am #13265
    abdul hakeem
    Participant

    Hi ,

    I am working with RN2483 Microchip…

    I established the communication between chip and gateway upto here fine,now i want to transmit the data from gateway to chip and how can i receive the data on chip side also….currently i am transmitting the data from chip by using “mac tx cnf 1 data” command then i am getting acknowledgement from gateway like “mac_rx data”,but here i want to transmit the data from gateway and receive the data at chip side..how can i do this…i didn’t found any specific command for receive the data like radio commands in radio communication we can use “radio rx 0” for receive the data from the chip in chip to chip communication.
    Thanks in Advance…..

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.