Cannot ssh into the MTCAP

Home › Forums › Conduit: mLinux Model › Cannot ssh into the MTCAP

Tagged: 

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 31, 2017 at 8:08 am #20482
    dibya mohanty
    Participant

    Hi,

    I received my MTCAP today and was following the quick start guide. I powered it up and connected to my computer with the LAN cable. I statically gave an IP address in my laptop. Now i can ping to the MTCAP but when i try to ssh using the default credentials root/root somehow i cannot get in. It asks me for the password again and again. I tried resetting it to the factory defaults as well but that also does not work.

    Any help is deeply appreciated.

    July 31, 2017 at 8:55 am #20483
    John Klug
    Moderator

    If you received an MTCAP with 3.3.6, the password was mistakenly set wrong. Here is the readme with the password at the end:

    http://www.multitech.net/mlinux/images/mtcap/3.3.6/Readme.txt

    August 1, 2017 at 3:32 am #20488
    dibya mohanty
    Participant

    Thanks John,
    Now it works. Is there a new version of the firmware? Is a firmware upgrade required?

    Can i somehow install the admin GUI similar to the conduit? Earlier with the MTCDT we used Node-Red. Can i install Node-red and work with it?

    August 1, 2017 at 9:11 am #20492
    John Klug
    Moderator

    The latest mLinux firmware for MTCAP is 3.3.9. http://www.multitech.net/developer/downloads/

    You will find Node Red under pre-built packages.

    http://www.multitech.net/mlinux/feeds/3.3.9/arm926ejste/node-red_0.15.3-r0.0_arm926ejste.ipk

    If you need an admin GUI, you will need to install AEP instead. If you have flashed mLinux over AEP, you will need to contact customer support.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.