Switch xDot to/from 868/915

Home › Forums › mDot/xDot › Switch xDot to/from 868/915

Tagged: 

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 13, 2017 at 6:55 am #17042
    Mark Ruys
    Participant

    Is it possible somehow to turn a 868 MHz xDot into a 915 MHz somehow? Or have these models different hardware?

    We’ll produce a lot of xDot end nodes, and it would logistically much easier if we could use a single xDot for different regions. Or at least configure a xDot for a certain region by flashing a different firmware in it. I know some (non-Multitech) MCU enabled LoRaWAN modules support both 868/915 in the same package.

    February 13, 2017 at 9:59 am #17059
    Peter Ferland
    Blocked

    The difference is regulatory – for the module to remain on Multitech’s FCC and CE certifications the product must leave our factory for one or the other regulatory environments.

    If you are manufacturing a separately certified product then something may be able to be arranged. Contact your sales contact at Multitech or your distributor to get that conversation started.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.