I contacted support and they were able to build me a UART0 firmware within a few hours. Awesome.
Thanks a lot for your help Jason.
Ah, right – wasn’t aware I could overwrite that.
I currently have SWDIO/SWCLK, UAR0T_TX/UART0_RX, GND, VCC and NRESET connected. Is that all that is required?
Thank you very much
I did erase it with an ST-LINK tool.
I’ve tried now flashing the AT firmware xdot-firmware-3.3.5-AU915-mbed-os-5.15.1-debug
, though when I open the serial monitor I’m unable to send any commands. It initially prints
[INFO] Set radio to Public Mode
[INFO] xDot Ready
Though after that does not allow any inputs.
Am I missing something?
Thank you!