Michael Selzler

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Problems connecting to AEP Conduit #10521
    Michael Selzler
    Participant

    Jeff,

    Via the debug port I’m able to capture a lot of startup information which for the most part looks okay (unless I’m missing something). The message file also contains nothing obvious to me. I could send the captured text file, but it is over 1200 lines of text. Here is something that I do see being repeated:

    mtcdt login: udhcpc (v1.22.1) started
    Sending discover…
    Sending discover…
    Sending discover…
    Usage: /etc/udhcpc.d/lanup {bound|renew|deconfig}
    run-parts: /etc/udhcpc.d/lanup exited with code 1
    No lease, failing

    I also saw this:

    Reading accessory cards data
    jffs2: notice: (168) check_node_data: wrong data CRC in data node at 0x0a2e5ee8: read 0x206ce7ab,
    calculated 0xa43b2c4.
    Adding accessory cards data

    Yes, I’m attempting to access the UI via the http://192.168.2.1.

    Thanks for your help!
    Mike

    in reply to: Problems connecting to AEP Conduit #10519
    Michael Selzler
    Participant

    I am unable to access the AEP interface; the browser times out attempting to pull up the login page. I’ve followed the “Getting Started with AEP” including installing a Mini SIM card (which was not included with the Conduit). The status LED is blinking twice with a short pause, then repeating. My conduit is a “201A” type model. Any suggestions would be greatly appreciated.
    Thanks,
    Mike

Viewing 2 posts - 1 through 2 (of 2 total)