UDK documentation problems
- This topic has 0 replies, 1 voice, and was last updated 9 years ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
1. I have several UDK2 boards, with no cellular. However I have been referring to documentation for the UDK with cellular, because, as far as I can tell, there is no specific document for the non-cellular boards. There are significant differences between what’s populated on the cellular and non-cellular versions.
2. The schematic that’s in the document (pp 50 – 54) is very difficult to read (blurry) and not searchable.
3. The “mDot header” section (sheet 4 of schematic, page 52 of pdf) is confusing. The pins 11-20 are NOT labeled very well – the header in fact, is labeled 1-10. There are two pins with an ‘X’ which normally indicates “no connection”, yet one of them clearly has a connection.