Network Join Error on new Gateway
- This topic has 1 reply, 2 voices, and was last updated 7 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Tagged: xdot join
Jason Reiss.
JonathanAHi,
Sorry if this is a stupid question but I am very new to this.
I was at a TTN conference and given an L-TEK FF1705 board (X DOT). At the conference, I programmed this up with the dot-examples and the libxdot-mbed5 libraries, registered with TTN and all went well.
Moving back home, there is a gateway very near to me. I get join errors-see below. Any ideas? If this is a channel issue, how do I change the channel?
[INFO] attempt 4 to join network
[INFO] Send join request RxDelay: 5 Rx1Offset: 0 Rx2Freq: 869525000 Rx2Dr: 0
[INFO] Configure radio for TX
[INFO] Configure radio for TX
[INFO] Configure radio for TX
[INFO] Configure radio for TX
[INFO] Rx Window 1
[INFO] Rx Window 2
[ERROR] Failed to join network
[ERROR] failed to join network -4:Join Error
[INFO] sleeping 5 s until next free channel
[INFO] entering sleep (stop) mode 00000037ý[INFO] attempt 5 to join network
[INFO] Send join request RxDelay: 5 Rx1Offset: 0 Rx2Freq: 869525000 Rx2Dr: 0
[INFO] Configure radio for TX
[INFO] Configure radio for TX
[ERROR] No enabled channel <===== only appears sometimes.
[ERROR] failed to join network -4:Join Error
Many thanks
Jason ReissEU868 joins on default channels so they should not be different unless you are in a different region.
Attempts at joining the network are limited by duty-cycle regulations in EU868. The device must wait after each attempt to maintain <1% time on air.
Do you know if the gateway is active?
How near is the gateway?
Is there any obstruction? Line-of-sight will give best chance of reaching.