MultiConnect Conduit isn't responding on Ethernet

Home › Forums › General › MultiConnect Conduit isn't responding on Ethernet

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 31, 2017 at 11:02 pm #16612
    Akshay Bhavsar
    Participant

    Hi there,

    I have successfully connected MultiConnect Conduit on Ethernet on my laptop. When I run 192.168.2.100 IP address in browser it was taking me to Multitech Dashboard. However, after powering off the device and trying again it doesn’t connect anymore.
    Windows Network Diagnostics shows following error
    ” Your computer appears to be correctly configured, but the device or resource (192.168.2.100) is not responding.

    I have tried couple of time. Even tried putting IP address and submask IP address under IPV4 setting of LAN connection.

    How can I resolve this ?

    Thanks
    Akshay

    February 1, 2017 at 8:38 am #16614
    Leon Lindenfelser
    Moderator

    Hi Akshay,

    Connect to the Conduit’s debug port and issue ifconfig to check its ethernet settings.
    http://www.multitech.net/developer/products/conduit/connecting-to-the-debug-interface/

    Kind regards,
    Leon

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.