MTAC-LORA-868 & Raspberry PI downlink
- This topic has 0 replies, 1 voice, and was last updated 8 years, 4 months ago by
.
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
DENIS FEDOROV.
DENIS FEDOROVGuys, hello.
I try make gateway on MTAC-LORA-868 & Raspberry PI.
Install lib&fwd from – https://github.com/mirakonta/lora_gateway
I can RX data without any problem. But TX not work.
I cannot receive data on modules but i see signal on spectrum analyzer.
is possible on this configuration ?
I make gateway by instruction from – https://github.com/mirakonta/lora_gateway/wiki1.
Additional add separate power to USB.
I try develop my own server.
And stuck on join confirm answer.
I try use util_tx_test from liblora.
Now i run on LoraMote rx-sensi application.
When i sent data from another LoraMote i can see this data on RX LoraMote.
But when i sent data from gateway, nothing.
./util_tx_test -f 868 -r 1257 -b 125 -s 10 -c 1 -l 8 -z 17
On LoraMote packet delivered 50/50.
May be signal very high on short range ?
All device on one table.
Thank’s