mdot send data to gateway.

Home › Forums › mDot/xDot › mdot send data to gateway.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 29, 2016 at 2:53 am #13666
    Khoa Tran
    Participant

    Hi guys,
    I use command AT+JOIN to join to join network.After that I send data to Conduit by using AT+SEND. First command , It’s ok but the next command the mdot send back “No enabled channel ERROR”.After that the mdot always send back “No enabled channel ERROR”.
    Help me.

    Thank you.

    Khoa Tran.

    June 29, 2016 at 8:38 am #13670
    Andrew Lindsay
    Participant

    How long did you wait between sending messages?

    June 29, 2016 at 8:12 pm #13676
    Khoa Tran
    Participant

    I wait about 10~15 seconds.

    • This reply was modified 9 years ago by Khoa Tran.
    June 30, 2016 at 2:44 am #13678
    Andrew Lindsay
    Participant

    Depending on your Spreading factor, you may need to wait longer. Try command AT+TXN which will show you the number of milliseconds before you can transmit again.

    Andrew

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.