mDot power range

Home › Forums › mDot/xDot › mDot power range

Tagged: ,

Viewing 1 post (of 1 total)
  • Author
    Posts
  • November 21, 2015 at 12:23 pm #10098
    Andrew Lindsay
    Participant

    I’m looking for the minimum voltage used to power the mDot, the mcu datasheet specifies 1.7 V to 3.6 V however the only thing I can find is pin 1 with a range VIN (3.5 TO 5V input). I’m assuming this goes through a voltage regulator to produce an internal 3.3V.

    Is there a way to run the mDot on a lower voltage?

    thanks

    Andrew

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.