mDot EVB/Box

[tweety.dayanna@hotmail.com]

I have a mDot Box/EVB US915 with Factory Firmware version 2.1.2.

When I select mode Survey Single, Survey Sweep or LoRa Demo appears a Joining screen with the following data:
”
Joining…
NI=MultiTech
NK=MultiTech
FSB=1
DR=0 P=20 A=Number increasing
”
I receive packages, but the screen in the mDot EVB never changes.

Any idea to solve this problem?
Thanks

• This topic was modified 7 years, 4 months ago by tweety.dayanna@hotmail.com.
• This topic was modified 7 years, 4 months ago by tweety.dayanna@hotmail.com.

[Steve Kovarik]

Hi Dayanna

Your mDot Box/EVB is attempting to “join” a LoRaWAN network with the NI, NK
and FSB parameters you posted. To solve the problem, you would need a
“LoRa Network Server” configured to accept a “Join” using the same parameters.
Do you have a “MultiTech Conduit” or some other “LoRa Network Server” server
for the MDot Box/EVB to Join.
If so how is it configured?

-Best Regards

[tweety.dayanna@hotmail.com]

Thanks for answering!
In LoRaWAN > Network Settings > LoRaWAN Network Server Configuration
*Channel Plan: US915
*Frequency Sub-Band: 1
In LoRaWAN > Key Management > Settings
*Local Network Settings
*Enabled: Checked
*Network ID (AppEUI): Name
*Name: MultiTech
*Network Key (AppKey): Passphrase
*Passphrase: MultiTech

• This reply was modified 7 years, 4 months ago by tweety.dayanna@hotmail.com.
• This reply was modified 7 years, 4 months ago by tweety.dayanna@hotmail.com.

[Steve Kovarik]

In the LoRaWAN Network Server Configuration there is also a check-box to
enable “Public”. I suggest to change that setting from what it is now, then
submit at the bottom of the screen then perform a “save & restart”.
A couple of minutes after the Conduit Gateway reboots, try to have the MDot
Box/EVB to “Join” again.

-Best Regards

[tweety.dayanna@hotmail.com]

I already have it configured as public

[Steve Kovarik]

Hi Dayanna

I would like you to try it as private by disabling (unchecking) “Public”
then “submit” at the bottom, then perform a “save & restart”. After the
Conduit has rebooted try the mDot Box/EVB.

[tweety.dayanna@hotmail.com]

Thank you so much, Steve!
It worked when I changed Network Mode to Private MTS.

• This reply was modified 7 years, 4 months ago by tweety.dayanna@hotmail.com.

[Author]

Posts