Mdot Configuration
- This topic has 0 replies, 1 voice, and was last updated 5 years, 9 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Good Day
I am new to the Mdot and Lora Protocol so please excuse me if I ask stupid questions.
My first issue is that not all commands is available on the Mdot box as what is available online. Firmware version is 2.0.0. Model MTDOT-EVB-868
Now my next question: I set the SF to 9. When I run the Lora demo, it still tries to connect on SF12? My setting in my network server is Class A Rx2_SF9(3rd party network server and gateway) however it only join successful when I set it on network server to 12. Any advise?
Now after successfully joined on SF12 I don’t receive data. Could it be that it is trying to send it via SF9 as that is what it is set to?
At one stage I did get data through but I disconnect and reconnect same problem occurs.
Any advice would be helpful.
Ian