Join manual mode and link check issue

Home › Forums › mDot/xDot › Join manual mode and link check issue

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • September 30, 2017 at 5:36 am #21031
    alejandro ballesta
    Participant

    Hi all,
    I’ve setup the xdot as manual join with NJM=0. Also link check is active with LCC=2 and LCT=2.
    NJS replies always 1.
    After a send operation there was a message “No response from network link check” and NJS changed to 0.
    If I try to send again, I cannot because of “network not joined” error.

    How can I revert this situation because I cannot send again? Will link check do this?

    MultiTech xDot
    Firmware: 2.0.14-(detached from 3699e9b)
    Library : 2.0.14-(detached from 7f6b74e)

    Thanks!

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.