Installing Node red in AEP 5.3.3
- This topic has 1 reply, 2 voices, and was last updated 4 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › Installing Node red in AEP 5.3.3
Steve Kovarik.
Sebastien LEFEVREI bought some new Gateway with AEP 5.3.3 Firmware.
I want to install Node Red Application. I did installation as said in a document and it works.
I restart my gateway but i can’t connect to Node red application and i don’t know if the service is started.
Can somebody help me ?
Thanks in advance
Steve KovarikHello Sebastien
Look in “Administration” and “Package Management” to see if there are installed packages as indication Node-Red is successfully installed.
When power is applied to the Conduit and after it boots-up and you are able to log into the device, Node-Red will take an additional 5 to 10 minutes to load.
If you are still unable to log into Node-Red after 10 minutes, it is possible that you configured eth0 as WAN and then to access Node-Red via a WAN interface you need to go to “Administration” then “Access Configuration” and for Node-Red
enable “Via WAN” scroll to the bottom and “Submit” then “Save and Apply”.
-Best Regards