Checking the frequency range of the Conduit

Home › Forums › Conduit: AEP Model › Checking the frequency range of the Conduit

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 12, 2016 at 1:04 am #15020
    Szymon Zieba
    Participant

    Hi,

    I have been trying to figure out how to determine what frequencies the Conduit is using when it is outputting a lora signal?
    This is due to the fact that I will be operating the device within the Australian ISM Band and need to ensure that the device, as set up, does not leave the ISM Band. I have the Australian Code loaded into the conduit as I understood using the beta code, but I would like to be able to make sure.

    October 12, 2016 at 6:52 am #15021
    Jason Reiss
    Keymaster

    The AEP 1.3.2 firmware has support for AU915.

    The LoRaWAN 1.01 protocol defines only 8 downlink frequencies between 915 and 928 MHz for use in AU915. Transmitting outside the range would non-compliant and unexpected by an end-device.

    http://www.multitech.net/developer/downloads/

    October 13, 2016 at 8:36 pm #15039
    Szymon Zieba
    Participant

    Thank you for your help.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.