I just had my header programming, and i tried a small program, but I can’t see the mDot connecting to my Lora network, so i tried to use the serial communication, and when I tried to use serial, I see a lot of message where they say that mDot is trying to connect, but can’t.. I can’t do command during this loop. So I saw that there was a topic where they say to reset the configuration, I made a small program with just reset configuration, save, set join mode in OTA, and save configuration, but I have the same problem, my mDot try to connect to the gateway but can’t…. Somoene have a solution pls?^^