AEP v5.0.0 MTCDT-LAT1 changes
- This topic has 4 replies, 2 voices, and was last updated 7 years ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › AEP v5.0.0 MTCDT-LAT1 changes
Tagged: admin login
Mike McNeil.
robert.miller@meau.comIm trying to figure out what the ip address is for a MTCDT-LAT1-247A It does not respond to 192.168.2.1 when I try to login via the rear USB port none of the username/password combinations work either. root/root admin/admin mtadm/root mtadm/admin. Did the factory ip address get changed and the user/password? its running AEP 5.0.0
robert.miller@meau.comAnd i reset it to factory already
Mike McNeilHello Robert,
The AEP 5.0.0 comes from factory and after a factory reset in Commissioning mode. The user has to create a new User and Pass, the admin/admin is not default anymore. The default IP is still 192.168.2.1.
Please refer to Chapter 2 of the Software Guide ( https://www.multitech.com/documents/publications/software-guides/s000727%20-%20mPower%20Edge%20Intelligence%20Conduit_AEP_software_guide.pdf ) for further information.
Refer to the following if using Curl:
Regards,
Mike
robert.miller@meau.comOK I am in. This brings up more questions. I had a batch file that I built to install other software that we use on this device, so now I need to add a bunch of curl commands before I can use my batch file. I would like to do the following..
1. Curl to set the username and password. – shown in the manual.
2. Curl to use a backup configuration file to set up the device with our settings. – The only command shown in manual is a back up. How do i “restore” from a backup file?
Mike McNeilI would try the upload_config command. You can use https://192.168.2.1/api/help/command for more information.
Regards.