AEP 1.7.2 has been released for MTCDT, MTCDTIP and MTCAP

AEP 1.4.16 has been released to replace the 1.4.14 release.

https://www.multitech.net/developer/downloads/
https://www.multitech.net/developer/software/aep/aep-firmware-changelog/

Changes

• Add channel for 923.6 for AS923 in 3rd MAC command sent to end-device after join
• Send AS923 commands after join in one downlink packet if downlink dwelltime is set to 0

Bug Fixes

• Fix: Include 13 byte header size in max packet calculations to conform with regional time-on-air regulations
• Fix: Send AS923 commands after join in three downlink packets if downlink dwelltime is set to 1 to fit in DR2

Known Issues

• AS923 – ADR cannot be used with DR6 and DR7, incorrect channel mask is set to be able to use the max DR

LoRa Network Server Changelog
Downloads Page

Changes

• Update default LBT threshold to -80 for AS923 according to Japan regulations
• Enforce downlink payload sizes according by datarate according to channel plan
• One uplink packet must be received before scheduling Class C downlink after a join
• Filter duplicate packets received on wrong channels by comparing RSSI/SNR. Duplicates were seen when end-devices are transmitting close to GW.

Bug Fixes

• Fix: use byte copy routine to stop alignment trap logged on join
• Fix: Calculation for max gateway tx power per channel plan with antenna gain. US915, AU915, IN865 plans

LoRa Network Server Changelog
Downloads Page

Lora Network Server 1.0.41 is available for download.

Changes

• Allow Class C packets to be sent without waiting for uplink after server reset
• Add IN865 Channel Plan
• MQTT username and password options

Bug Fixes

• Fix: Only one packet will be scheduled with Channel Mask or Additional Channels in first downlink. This packet will be sent until device ACK’s receipt.

LoRa Network Server Changelog
Downloads Page

An updated package is available for download.
This package includes an new init.d script to create symlinks to the correct packet forwarder binary based off installed MTAC-LORA hardware product and version information.

Note: Installing this packet will reset the /etc/default/lora-packet-forwarder setting to disabled.
This update is needed for mLinux 3.3.6+ installations configured in packet forwarder mode.

Conduit mLinux: Convert to Basic Packet Forwarder

AEP packet forwarder mode configured through the GUI is not affected.

http://www.multitech.net/downloads/lora-packet-forwarder_3.1.0-r9.1_mtcdt.ipk