Selecting frequency sub band
- This topic has 0 replies, 1 voice, and was last updated 6 years, 11 months ago by
.
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › Selecting frequency sub band
kerem.kos@boostdesign.com.au.
kerem.kos@boostdesign.com.auHi,
We have a product which will be tested for AS/NZS 4268 standards.
It seems like we have to enable all channels and use all by frequency hopping to pass the test.
AT the Mdot part I initiated the device using AT+FSB=0 and then check the transmit channels by command AT+TXCH and see that all channels are enabled.
My problem is frequency sub band options on the conduit are 1 to 8. I can not find how to enable all sub bands (if it is possible). Since I can not set the conduit part correctly, Mdot can not connect to the conduit.
The reason I am actually trying to connect and communicate to the conduit is to verify the packets send from the Mdot really hop between 64 channels. If there is an easier way to test it, that would be ok as well.
Thanks