how to use serial interface in xDot dongle device

Home › Forums › mDot/xDot › how to use serial interface in xDot dongle device

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • September 14, 2017 at 5:33 am #20936
    Daniel Amsalem
    Participant

    Hi

    i’m using the xDot dongle MTMDK-XDOT.
    I’m trying to simulate at commands UART1 interface by using local CPU (msp430) connected to xDot dongle UART1 rx/tx points (without flow control).

    is it possible to overload these signals ?

    I can see both signals reflected on those pins (on scope) yet when I’m trying to write an AT command the UART1_RX not affected.

    Thank you
    Danny

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.