Conduit port configs with IPv6

Home › Forums › Conduit: AEP Model › Conduit port configs with IPv6

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 9, 2017 at 4:40 am #20898
    Boyko Vesselinov
    Participant

    Hello all,

    We are trying to integrate a Watecco device, requiring IPv6 overheads and comunication on port 6. We define port 6 in Lora output node. Do we have to make any changes in advanced Lora config to UDP listening ports and buffer sizes?

    Boyko

    September 9, 2017 at 11:12 am #20899
    Jason Reiss
    Keymaster

    The lora-out node communicates to end-devices through network server over lora rf. The port field is application specific.

    Ipv6 would be used to communicate with outside world via ethernet. An application (node-red) in conduit should be used to setup the external connection and forward packets to and fro.

    No changes to lora config should be necessary as lora communication to application is local.

    September 11, 2017 at 9:28 am #20909
    Boyko Vesselinov
    Participant

    Thanks Jason.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.