Hey guys, I get an MTCDTIP L4N1 to put in our lorawan red, when I plug it into the poe the LEDs are solid green (the first one) and solid red (the last one). I can’t access it in any form, I don’t know if it has mPower or AEP or mLinux, there is a way to flash it from zero with the debug port or something like that?

Thanks in advance.

EDIT: I finally get something from this device, with debug port I get some information on the boot process and it seems it’s trying to flash it self with a wrong file.

AT91Bootstrap 3.8.12-m2 (Tue May 26 09:00:31 CDT 2020)/MTechONFI

NAND: ONFI flash detected
NAND: Manufacturer ID: 0x2c Chip ID: 0xaa
NAND: Page Bytes: 2048, Spare Bytes: 64
NAND: ECC Correctability Bits: 4, ECC Sector Bytes: 512
NAND: Disable On-Die ECC
PMECC: version is: 0x101
PMECC: page_size: 2048, oob_size: 64, pmecc_cap: 4, sector_size: 512
NAND: Initialize PMECC params, cap: 4, sector: 512
NAND: Image: Copy 0x80000 bytes from 0x40000 to 0x2ef00000
NAND: Done to load image
CPU: AT91SAM9G25
Crystal frequency: 12 MHz
CPU clock : 400 MHz
Master clock : 133.333 MHz
Watchdog enabled
I2C: ready
DRAM: 256 MiB
WARNING: Caches not enabled
NAND: 256 MiB
MMC: mci: 0
env_relocate_spec: crc1_ok=1 saved crc=0x46b1a5a3 calculated crc=0x46b1a5a3 flags=0
env_relocate_spec: crc2_ok=1 saved crc=0x46b1a5a3 calculated crc=0x46b1a5a3 flags=0
In: serial
Out: serial
Err: serial
vendor-id: Multi-Tech Systems
product-id: MTCDTIP-L4N1-266A
device-id: 21124377
hw-version: MTCDTIP-0.0
mac-addr: 00:08:00:4b:1c:b0
Net: macb0
Hit any key to stop autoboot: 0

Loading from nand0, offset 0x200000
** Unknown image type
Wrong Image Format for bootm command
ERROR: can’t get kernel image!
Enter password :