Home › Forums › Lora Network Server › Multitech Conduit mLinux 5.0 cannot connect Thething
Tagged: multitech conduit
Jason Reiss.
locnp@digisensor-co-ltd.comHi all,
Hi,
After update mlinux upto 5.0 I cannot connect thething. Thething status is “not connect”.
Multitech conduit mlinux return:
//////////////////////////////
Description (from TTN):
Frequency plan (from TTN): IN_865_867
Is the information correct?
1) Yes
2) No
#? 1
Stopping existing forwarder
Stopping ttn-packet-forwarder: start-stop-daemon: warning: failed to kill 1350: No such process
killall: mp_pkt_fwd: no process killed
OK
Get up-to-date TTN configuration for packet forwarder
installer.sh: line 822: node: command not found
Starting ttn-packet-forwarder: OK
The installation is now complete.
Check the gateway output using:
tail -f /var/log/lora-pkt-fwd.log
(It might take some minutes for the first output to appear!)
Check the gateways last seen status in the TTN console after
a few minutes to verify the setup is working correctly
///////////////
Jason ReissIt does not appear that the TTN installer currently has support for mlinux 5.0.0. This would need to be provided by TTN.
Also the mlinux-factory-image should be used as it has support for nodejs.
installer.sh: line 822: node: command not found
The device should be downgraded to a version supported by TTN or the TTN installer not used until it is supported.
Otherwise you could install the mlinux-factory-image 5.0.0 or AEP 5.0.0 and use the already installed Semtech packet forwarder to connect to TTN.
AEP would be easiest to configure, there is a dropdown and region selector.
Replace the server information in the configurations above with the TTN info according to your region.
https://github.com/TheThingsNetwork/gateway-conf
“server_address”: “router.as1.thethings.network”,
“serv_port_up”: 1700,
“serv_port_down”: 1700,
locnp@digisensor-co-ltd.comHow can i downgrade to old mlinux version ?
Jason ReissFollow the flashing procedure with a images from the previous version.
jot4pHi,
What is the logic of dropdown with PACKET FORWARDER > Server
> Network > “The Things Network” .. if it’s necessary to install the file “install.sh” from ttn ?
Jason ReissIt is not necessary to install the TTN forwarder.
Check “I’m using the legacy packet forwarder” in TTN when registering the gateway.