XDOT NA1-00 MODULE ERR MESSAGE

Home › Forums › mDot/xDot › XDOT NA1-00 MODULE ERR MESSAGE

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 14, 2017 at 9:12 pm #19042
    son hyochul
    Participant

    hI
    XDOT NA1-00 MODULE ERR MESSAGE
    Even if reset, the same message is repeated even if “+++” is sent.
    Tell me how to change back to AT terminal mode.(delete lora config )

    The same is true if the firmware is rewritten.
    Reset timing is too fast, so +++ can not be input

    —————————————————————————–

    [tera term monitor display message]
    Joining network…
    Joining network…
    Joining network… Network Join failed

    ERROR

    Joining network… Network Join failed

    ERROR

    Joining network… Network Join failed

    ERROR

    Joining network…
    Waiting 1 s before next join attempt
    Network Join failed

    ERROR

    Joining network…
    Waiting 1 s before next join attempt
    Network Join failed

    ERROR

    Joining network… Network Join failed

    ERROR

    Joining network…
    Joining network… Network Join failed

    ERROR

    Joining network…
    Waiting 1 s before next join attempt
    Network Join failed

    ERROR

    Joining network…
    Waiting 1 s before next join attempt

    June 14, 2017 at 4:38 pm #19542
    Mark Ruys
    Participant

    Upload a hello world application to your xDot which changes the join from AUTO_OTA to OTA. Run it once, then flash back the AT firmware.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.