Exit from Auto OTA join fail

Home › Forums › mDot/xDot › Exit from Auto OTA join fail

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 30, 2016 at 8:27 am #14654
    Denis Beraldo
    Participant

    Hi,

    I need to exit from Auto OTA Network join mode after fail.
    But every time when the mDots starts (after reset) it tries to connect and AT command interface is disabled.

    In my case the Conduit is powered off, so, mDot trying to connect forever and don’t enable AT interface.

    Is there a scape command like +++ to stop this?

    Thanks in advance,
    Denis

    August 30, 2016 at 4:05 pm #14674
    Jason Reiss
    Keymaster

    Yes, +++ will escape the join sequence.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.