{"id":27433,"date":"2019-03-18T11:38:22","date_gmt":"2019-03-18T16:38:22","guid":{"rendered":"http:\/\/www.multitech.net\/developer\/?page_id=27433"},"modified":"2025-01-06T13:04:27","modified_gmt":"2025-01-06T19:04:27","slug":"mtac-xdot","status":"publish","type":"page","link":"https:\/\/www.multitech.net\/developer\/products\/multiconnect-conduit-platform\/accessory-cards\/mtac-xdot\/","title":{"rendered":"MTAC-XDOT"},"content":{"rendered":"

The xDot\u00ae\u00a0<\/sup>Accessory Card (MTAC-DOT) is a LoRa WAN, low-power RF device, capable of two way communication over long distances, deep into buildings, or within noisy environments.<\/p>\n

\"MTAC-XDOT\"<\/p>\n

AT Command Port<\/h3>\n

Depending on installed slot the AT command port is the following paths in mPower 6.0.x and later.<\/p>\n

sudo minicom -D \/dev\/ttyAP1
\nor
\nsudo minicom -D \/dev\/ttyAP2<\/p>\n

 <\/p>\n

Note: Hardware flow control may be enabled by default<\/p>\n

CTRL-A, o, Serial port setup, F
\n— Select F – Hardware flow control: No<\/p>\n

<\/h3>\n

Debug port<\/h3>\n

\/dev\/ttyACM0 if only one card is installed<\/p>\n

 <\/p>\n

Links<\/h3>\n