Installing a Battery

The battery is located in the Conduit housing.

You need:

  • Phillips screwdriver
  • If replacing a battery, non-metal tweezers or similar object
  • CR1632 standard coin lithium battery


To install or replace the battery:

  1. If connected, disconnect power to the Conduit.
  2. At the front of the Conduit housing, remove the screw that secures the MultiTech nameplate to the housing.
  3. The battery holder is located at the right side of the opening on the underside of the PC board. To remove an existing battery, use non-metal tweezers as necessary.
  4. Orient the new battery so that the positive (+) pole is facing down. Use your fingers or non-metal tweezers to insert the battery into the holder.
  5. Reattach the MultiTech nameplate to the housing using the screw removed in Step 2.


CAUTION: Risk of explosion if this battery is replaced by an incorrect type. Dispose of batteries according to the instructions.


ATTENTION: Risque d’explosion si vous remplacez la batterie par un modèle incompatible. Jetez les piles usagées selon les instructions.