Using AEP packet forwarding with Semtech demo server

Home › Forums › Conduit: AEP Model › Using AEP packet forwarding with Semtech demo server

Tagged: ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 9, 2019 at 9:17 am #28320
    bob.crichton@hop.co.uk
    Participant

    I am new to this, so please excuse my ignorance.

    I recently received a Conduit AP and upgraded firmware to 5.0.0. Initially I set it up as a network server and proved that I could receive packets from a LORA endpoint (Elsys sensor). I then reconfigured for packet forwarding and am using the Semtech demo server for testing. The gateway is recognised by the server but no packets from the endpoint are getting through.

    What am I doing wrong? Thanks.

    August 16, 2019 at 11:45 am #28349
    Steve Kovarik
    Moderator

    Hi Bob

    Having success using the LoRa Network Server on the Conduit proves you have
    configured both the Elsys and Conduit correctly.
    When using the Conduit as a Packet Forwarder you will need to configure the
    Elsys and Semtech server with appropriate keys. If the Elsys fails OTAA
    join are you able get any logging or error messages from the Semtech server?

    If you enable ssh on the Conduit you can monitor “packets” being sent by doing a tcpdump on the WAN interface. If Ethernet is WAN then tcpdump -i eth0 -AUq port 20000

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.