Receive Sensitivity for Conduit and Conduit AP LoRa modem?

Home › Forums › General › Receive Sensitivity for Conduit and Conduit AP LoRa modem?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 2, 2018 at 3:59 pm #26437
    andrew@bitfinder.co
    Participant

    Hi,

    Are the specs for the receive sensitivity for RX for the LoRa modem in the Conduit and Conduit AP products listed anywhere? I check the datasheet, and unless I missed it, it does not appear to be tabulated there.

    I am presently only receiving messages down to an RSSI of -108dBm (on Conduit AP), and I would like to test the range versus RSSI versus packet miss rate for the most extreme cases.

    October 10, 2018 at 10:24 pm #26499
    andrew@bitfinder.co
    Participant

    It would be great to have an answer to this.

    October 22, 2018 at 3:32 pm #26612
    andrew@bitfinder.co
    Participant

    Just to close this out, for anyone else who comes looking for this same information:
    Extensive RF testing reveals that the receive sensitivity of the Conduit AP model is -110dBm, and for US915 DR3 and DR4, packets cannot be received below this level.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.