Problem received datas doesn’t appear in the debug window node-red

Home Forums Conduit: AEP Model Problem received datas doesn’t appear in the debug window node-red

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #23919
    Antoine Harlé
    Participant

    Hi everyone,
    I’ve some sensors that I registered and it was working of a specific network.
    Then, I have changed my network and I’ve done again the configuration of my multitech conduit. But now, I registered my sensors that communicate with the gateway (I see up, down, and 1st, as shown on the screenshot below) and I don’t receive the trames on node-red, nothing appears in the debug window.
    I’m on this problem for 2 days, without improvement.
    Could anyone help me ? I don’t really know what could be the problem.
    Thanks by advance
    https://www.noelshack.com/2018-25-3-1529503130-problem-screenshot.png

    #23921
    Jason Reiss
    Keymaster

    The device may be joining only? Otherwise the seq num would have been incremented.

    To see uplink and downlink packets on command line.
    # mosquitto_sub -v -t lora/+/+

    Otherwise have a look at the GUI on AEP, LoRaWAN > Packets page

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.