mDot at firmware – end of at command

Home › Forums › General › mDot at firmware – end of at command

Tagged: , , ,

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 11, 2018 at 11:13 am #25615
    thomas@novamar.no
    Participant

    Hi

    I can not seem to find any documentation related to how an AT command should be ended when writing to the serial port of the mDot.

    Which one of these is it?

    \n \r or \n\r

    Best regards

    Thomas H

    July 11, 2018 at 11:28 am #25616
    Jason Reiss
    Keymaster

    \r\n

    July 11, 2018 at 12:17 pm #25619
    thomas@novamar.no
    Participant

    Hi

    Thanks.

    Do you know what could be causing missing characters over uart? Had the same problem using the developer board connected to the Mdot, as well as my own MCU. (EFM32).

    I have checked that the serial settings are okey.

    July 11, 2018 at 1:15 pm #25620
    thomas@novamar.no
    Participant

    Nvm, issues resolved after using correct endings. Thank you so much.

    —
    Thomas

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.