HARD RESET AEP

Home › Forums › Conduit: AEP Model › HARD RESET AEP

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 7, 2019 at 9:25 am #27200
    jot4p
    Participant

    Hi,

    I change some code via SSH .. the code is mlinux inside AEP ? It’s possible to HARD reset all code ? Factory bin don’t change the files in the system..

    February 7, 2019 at 9:47 am #27204
    Jeff Hatch
    Keymaster

    Jot,

    Did you change an init script or something? The factory reset only reverts the configuration to factory settings. It does not reset any changes to the init scripts or executable binaries. You may need to re-flash the device from tftp:

    http://www.multitech.net/developer/software/mlinux/using-mlinux/flashing-mlinux-firmware-for-conduit/

    Jeff

    February 12, 2019 at 6:14 am #27223
    jot4p
    Participant

    Yeah, I saw this but my version is AEP, how do I install AEP later?

    February 12, 2019 at 8:39 am #27227
    Jason Reiss
    Keymaster

    Perform a firmware upgrade with the same version of AEP if the system is functioning enough to run the web UI.

    Otherwise the upgrade.bin file from AEP can be used via ssh as detailed in the Using Auto-Flash During Reboot with image upgrade.bin section of the linked document above.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.