Connection failed; try to connect m/xdot to a conduit AEP

[William Huang]

Hi All,

I have tried to use the link below,
http://www.multitech.net/developer/software/lora/getting-started-with-lora-conduit-mlinux/
to try to connect my xdot or mdot to Multi-tech conduit model AEP. But when I use AT+SEND, the message was not sent due to “Network not joined”. As consequence, nothing will show in Node-RED.

So does anyone has experience with setting up m/xdot with conduit AEP before or recommend any setup guide?

Thanks

[Steve Kovarik]

Hi William

If you have the Conduit AEP you should follow the instructions at this
link http://www.multitech.net/developer/software/lora/getting-started-with-lora-conduit-aep/

The video at the link below should also be helpful.

-Best Regards

[William Huang]

Hi Steve,

Would it be the same procedures if I do it with the Xdot? Also, I do not have the UDK.

Best Regards

[Steve Kovarik]

Hi William

Yes, if configuring a Dot with AT Commands the commands are the same for
for a mDot and xDot. If you are still unsuccessful to “join” and “send”
data to the Conduit we would recommend you open a Support Portal case
so we can review the Dot settings (at&v) and the Conduits LoRa Network settings. Let us know how it goes.

-Best Regards

[William Huang]

Hi, Steve.

I have successfully join the network and send string by just changing my channel plan from US to AU.

Best Regards

[Author]

Posts